For installation during construction, the SEAMAID mini-projector lights up specific areas of the pool.Screws into a vacuum fitting or wall fitting with a 1.5” thread.

Did you know? The rear of the plug has a 1.5” male thread to make the SEAMAID mini-projector easier to install, as no specialist tools are required.

Pictures and videos
Specifications
Ideas and recommendations

These pool projectors must be connected to a two-coil insulated safety transformer that is at least 20% more powerful than the total power absorbed by the connected projectors. It is important to check the compatibility of the vacuum fitting before finalising installation. Certain models equipped with a stop thread are not suitable. The wall fitting will be connected to the connection box with watertight conduit. For best results, use connection accessories from SEAMAID to guarantee a completely waterproof installation.

Roll the extra cable up in the connection box to ensure that you will be able to replace the projector in the future out of the water. As an optional extra, you may install a radio switch between the lamp (or group of lamps) and the ~12V transformer in order to remotely turn the device on and off, or synchronise multiple devices.

Complementary products

REMOTE CONTROL SWITCH

Downloadable documents

2019 Catalogue

This practical, technical catalogue is a must-have for professionals looking for projectors that are easy to install and use.

Download